Alternative low-power plasma-sprayed inconel 625 coatings for thermal solar receivers: Effects of high temperature exposure on adhesion and solar absorptivity, D. Merino-Millan, C. J. Múnez, M. Á. Garrido-Maneiro, P. Poza, Solar Energy Materials and Solar Cells, 245, 111839, 2022, Online version, https://doi.org/10.1016/j.solmat.2022.111839

Abstract

Over recent years, renewable energy technologies have focused on increasing performance and efficiency, and on the reduction of maintenance costs. In this work, thermal-sprayed Inconel 625 coatings have been studied as an alternative for concentrated solar power plants receivers. A low-power compact plasma spray system was used to deposit coatings onto two substrates: grade 22 ferritic steel and AISI 316 L austenitic steel. This system may be used for in-situ maintenance or repair purposes. The coatings were heat-treated at two temperatures: 520 °C and 800 °C, at different exposure times. The aim of this work was to evaluate the effect of this treatment on the adherence and solar absorptivity of the Inconel 625 coatings. The results showed that, at higher temperatures and longer exposure times, better adherence and absorptivity are achieved. Adherence values above 60 MPa were obtained due to diffusion in the coating-substrate interface. Additionally, absorptivity values above 93% were measured due to oxide formation on the coating surface during heat treatment. Furthermore, the highest temperature of the oxidized treatment reported the highest values of absorptivity. These results show that the developed Inconel 625 coatings could be considered as a possible alternative to improve the performance of concentrated solar power plants.